… all FFT bins are returned for an 8k FFTlength at SR = 65536 Hz, the Sweep Panel should be set up as shown in Figure1b. With the sweep panel properly configured, once the sweep is completed, theFFT spectrum…
… digitalinput #1 of the analyzer. You can then use the Digital Interface Analyzer (intervu)program as shown in the accompanying test file example “jitter PSIA BCK to AES BNC.at27.” This test file will…
… problems. You will need one adapter for each channel to be converted. The wiring diagram is shown in Figure 2. For balanced outputs, each of the two terminals of the balanced connection should have one…
In this two-part series, we’ll review the features available in APx500 software to help ensure that settled readings are acquired when testing audio devices.
… of the 2700 Series.
THD+N Our conservatively spec’d system residual THD+N is less than –112 dB, as shown in the graph below. This represents an advantage of about 9 dB over converter-based analyzer systems.…
… is conducted. The sweep panel configurations we are using for theSYS-2722 and ATS-2 are shown in Figures 1 and 2 respectively.
Figure 2 ATS-2 Sweep panel configuration. The sweep starts by…
If you look at any APx measurement using a log-swept sine stimulus (a chirp), you might notice that the signal is always swept from low to high frequency. Learn more about why chirps are always swept
… analog balanced inputs of an APx585. When I generate a sine wave signal into the receiver, the APx shows a strangely distorted waveform with a level much lower than expected. What is wrong?
Answer
Most…
